Yamaha DVR-S200 Owner's Manual page 100

Appendix
No sound except from the Front
Speakers.
1 You are listening to STEREO sound.
Cause
Press STEREO and make sure sound field
Solution
effect is on.
2 You are playing a source such as Dolby
Cause
Surround, Dolby Digital or DTS that doesn't
contain a special effect signal.
Select another DSP Program.
Solution
3 A digital audio sampling frequency over 48
Cause
kHz is input.
A digital audio sampling frequency over 48
kHz only outputs from the Front Speakers.
No sound from the Center Speaker.
1 You turned off the Center Speaker volume
Cause
level.
Turn up the Center Speaker volume. See
Solution
page 61.
2 You set "* CENTER" in the SET MENU to
Cause
"NON".
Set the Center Speaker correctly. See page
Solution
64.
3 You have selected a DSP Program from the
Cause
Music group (excluding 5ch Stereo).
Select another DSP Program. See pages 16
Solution
and 17.
4 Dolby Digital and DTS sources do not
Cause
contain a center channel signal.
98
No sound from the Surround Speakers.
1 You turned off the Surround Speaker
Cause
volume level.
Solution Turn up the Surround Speaker volume. See
page 61.
2 CinemaStation plays a monaural source in
Cause
the Theater DSP Program.
Solution Select another DSP Program. See pages 16
and 17.
No sound from the Subwoofer.
1 You set "* BASS" in the SET MENU to
Cause
"FRONT" when CinemaStation plays a
Dolby Digital or DTS source.
Set "* BASS" to "SWFR" or "BOTH". See
Solution
page 64.
2 You set "* BASS" in the SET MENU to
Cause
"FRONT" or "SWFR" when CinemaStation
plays a 2-channel source.
Solution
Set "* BASS" to "BOTH". See page 64.
3 The source doesn't contain an LFE or other
Cause
low tone signal (below 90 Hz).
No low tones.
The Speaker mode you selected in the SET
Cause
MENU does not match your speaker.
Set the appropriate Speaker mode based on
Solution
the size of the speakers you are using. See
page 63.
Strange humming noises.
You did not connect the pin cable properly.
Cause
Check your pin cable connections.
Solution