GE Monogram ZGG300LBPSS Dimensions And Installation Information

ZGG300NBPSS - Natural Gas Built-in Outdoor Grill
ZGG300LBPSS - LP Gas Built-in Outdoor Grill
Dimensions and Installation Information (in inches)
12" Min. to Combustibles
4" Min. Clearance for Lid
to Non-Combustibles
*25-1/2"
Countertop Depth
27" to Front
of Control Panel
28-1/2" to Front of Bullnose
*The weight of the grill is fully supported by
the side trims. The back of the grill overlaps
the back edge of the cutout.
For answers to your Monogram,
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
800.626.2000.
27"
29-7/8"
10-1/4" from
Bottom of
Support Flange
GE Profile or
® ™
service,
®
Outdoor Built-in Cooktop
These grills are designed to be installed into a non-
combustible enclousure.
• The grill drops into the opening and hangs from
the side flanges. It does not require support from
the bottom.
26"
• The cutout must be completely covered with
non-combustible material such as stone, brick,
ceramic tile, concrete board, etc. The countertop
surface and edges must be flat and level.
• If the countertop has an overhang, it must be
notched or cut back flush with the front face of
the cabinet below.
• Allow at least 12" minimum clearance at the
back of the grill when the exhaust is directed to a
window or surface that is difficult to clean. Allow
at least 4" clearance behind the grill to allow the
hood lid to open. See notched detail below.
• Allow 12" minimum clearance on both sides
and the back of the grill to adjacent vertical
combustible construction.
• These gas grills cannot be used below any type of
overhead construction.
• These grills are designed for outdoor use only. Do
not locate the cooktop in a building, garage or
other enclosed or semi-enclosed area.
• Locate the backside of the grill away from
prevailing winds and avoid cooking in windy
conditions.
28-3/4"
24-1/2"
Grill Cutout
36"
1-1/8" Min.
Min.
Specification Created 10/08
Gas and
Electrical
Locations
10-7/8"
Opening
for Optional
Access Doors
170133