Ad" Crankshaft Bolt Loosening; Ae" Crankshaft Sprocket Removal; Af" Timing Belt "B" Removal; Ag" Counterbalance Shaft Sprocket - Mitsubishi 4G6 series Workshop Manual

11A-4-4
E
Mitsubishi Motors Corporation
4G6 ENGINE (E - W) -

AD" CRANKSHAFT BOLT LOOSENING

(1) Hold the drive plate with the special tool as shown.
(2) Remove the crankshaft bolt.

AE" CRANKSHAFT SPROCKET REMOVAL

(1) If it is difficult to remove the sprocket, use the special

AF" TIMING BELT "B" REMOVAL

(1) Make a mark on the back of the timing belt indicating
6EN1322

AG" COUNTERBALANCE SHAFT SPROCKET

(1) Set the special tool as shown to prevent the
MD998785
(2) Loosen the bolt and remove the sprocket.
Aug. 1998
Timing Belt
tool.
the direction of rotation so it may be reassembled in the
same direction if it is to be reused.
NOTE
(1) Water or oil on the belt shortens its life drastically,
so the removed timing belt, sprocket, and tensioner
must be free from oil and water. These parts should
not be washed.
contaminated.
(2) If there is oil or water on each part check front case
oil seals, camshaft oil seal and water pump for leaks.
REMOVAL
counterbalance shaft sprocket from turning together.
PWEE9616-A
Replace parts if seriously
Revised