Mitsubishi 4G6 series Workshop Manual page 107

4G6 ENGINE (E - W) -
E
Mitsubishi Motors Corporation
Crankshaft, Flywheel and Drive Plate
(4) Bore all cylinders to the calculated boring finish dimension.
(5) Hone to final finish dimension (piston O.D. + clearance
(6) Check clearance between piston and cylinder.
Aug. 1998
Caution
D
To prevent distortion that may result from
temperature rise during honing, bore cylinders,
working from No. 2, No. 4, No. 1 to No. 3.
between piston O.D. and cylinder).
Clearance between piston and cylinder:
0.02 - 0.04 mm
NOTE
When boring cylinders, finish all of four cylinders to same
oversize. Do not bore only one cylinder to an oversize.
PWEE9616-A
11A-12-7
Added