Photocapture Center™ Difficulties; Software Difficulties - Brother MFC-J4410DW Basic User's Manual

PhotoCapture Center™ Difficulties
Difficulty
Removable Disk does not work
correctly.
Cannot access Removable Disk
from the computer.
Part of my photo is missing when
printed.

Software Difficulties

Difficulty
Cannot install software or print.
"Device Busy"
Cannot print images from
FaceFilter Studio.
®
(Windows )
Network Difficulties
Difficulty
Cannot print over the network.
110
Suggestions
1 Take out the memory card or USB Flash memory drive and put it back in
again.
2 If you have tried "Eject" from within Windows
USB Flash memory drive before you continue.
3 If an error message appears when you try to eject the memory card or USB
Flash memory drive, it means the card is being accessed. Wait a while and
then try again.
4 If all of the above do not work, turn off your PC and machine, and then turn
them on again.
Make sure that you have correctly inserted the memory card or USB Flash
memory drive.
Make sure that Borderless printing and Cropping are turned off. (See Advanced
User's Guide: Borderless printing and Cropping.)
Suggestions
®
(Windows only)
Run the Repair MFL-Pro Suite program on the CD-ROM. This program will repair
and reinstall the software.
Make sure the machine is not showing an error message on the Touchscreen.
To use FaceFilter Studio, you must install the FaceFilter Studio application from
the CD-ROM supplied with your machine. (See Quick Setup Guide.)
Also, before you start FaceFilter Studio for the first time, you must make sure your
Brother machine is turned on and connected to your computer. This will allow you
to access all the functions of FaceFilter Studio.
Suggestions
Make sure that your machine is powered on and is online and in the Ready mode.
Print a Network Configuration Report (See Advanced User's Guide: Reports.) and
check the current Network settings printed in this list. Reconnect the LAN cable to
the hub to verify that the cabling and network connections are good. If possible,
try connecting the machine to a different port on your hub using a different cable.
If the connections are good, the machine shows LAN Active for 2 seconds.
If you are using a wireless connection or are having Network problems,
see Network User's Guide: Troubleshooting.
®
, take out the memory card or