ZyXEL Communications Vantage Report User Manual page 630

Appendix B ZyWALL USG Series and ZyWALL 1050 Log Descriptions
Table 284 Device HA Logs (continued)
LOG MESSAGE
Device HA VRRP
interface %s for VRRP
Group %s has changed.
Device HA syncing from
%s starts.
%s has no file to
sync, Skip syncing it
for %s.
Master configuration
is the same with
Backup. Skip updating
it.
%s file not existed,
Skip syncing it for %s
Master firmware
version can not be
recognized. Stop
syncing from Master.
Device HA Sync has
failed when syncing %s
for %s due to bad
\"Sync Password\".
Device HA Sync has
failed when syncing %s
for %s due to bad
\"Sync From\" or
\"Sync Port\".
Device HA Sync has
failed when syncing %s
for %s.
Sync Failed: Cannot
connect to Master when
syncing %s for %s.
Backup firmware
version can not be
recognized. Stop
syncing from Master.
630
DESCRIPTION
Configuration of an interface that belonged to a VRRP group
has been changed, 1st %s: VRRP interface name, 2nd %s:
%s: the name of VRRP group.
Device HA Syncing from Master starts when user click "Sync
Now" using Auto Sync, %s: The IP of FQDN of Master.
There is no file to be synchronized from the Master when
syncing a object (AV/AS/IDP/Certificate/System
Configuration), But in fact, there should be something in the
Master for the device to synchronize with, 1st %s: The
syncing object, 2nd %s: The feature name for the syncing
object.
The System Startup configuration file synchronized from the
Master is the same with the one in the Backup, so the
configuration does not have to be updated.
There is no file to be synchronized from the Master when
syncing a object (AV/AS/IDP/Certificate/System
Configuration), But in fact, there should be something in the
Master for the device to synchronize with, 1st %s: The
syncing object, 2nd %s: The feature name for the syncing
object.
Synchronizing stopped because the firmware version file was
not found in the Master. A Backup device only synchronizes
from the Master if the firmware versions are the same
between the Master and the Backup.
The synchronization password was incorrect when attempting
to synchronize a certain object (AV/AS/IDP/Certificate/System
Configuration).
1st %s: The object to be synchronized, 2nd %s: The feature
name for the object to be synchronized.
The Sync From IP address or Sync Port may be incorrect when
synchronizing a certain object (AV/AS/IDP/Certificate/System
Configuration).
Synchronization failed when synchronizing a certain object
(AV/AS/IDP/Certificate/System Configuration) due to an
unknown reason, 1st %s: The object to be synchronized, 2nd
%s: The feature name for the object to be synchronized.
Synchronization failed because the Backup could not connect
to the Master. The object to be synchronized, 2nd %s: The
feature name for the object to be synchronized.
The firmware version on the Backup cannot be resolved to
check if it is the same as on the Master. A Backup device only
synchronizes from the Master if the Master and the Backup
have the same firmware versions.
Vantage Report User's Guide