ZyXEL Communications Vantage Report User Manual page 529

Table 227 Logs > Log Viewer > All Logs
LABEL
End Time
Days
Start Date
End Date
Category
Severity
Reverse DNS
Advanced Search
Source IP
Services
Destination IP
Protocol
Vantage Report User's Guide
DESCRIPTION
Enter the time of the latest log entries you want to see, if you select
Day.
Select this if you want to look at log entries for a specific range of
days.
This field is enabled and required if you select Days. Enter the date of
the earliest log entries you want to see. You cannot enter a date
earlier than the number of previous days that you configured in the
System Setting > General Configuration screen. You can also
click the Calendar icon to specify the date.
This field is enabled and required if you select Days. Enter the date of
the latest log entries you want to see. You cannot enter a date earlier
than Start Date or later than today. You can also click the Calendar
icon to specify the date.
This field can vary according to which device the logs are collected
for.Vantage Report.
Select what type of log entries you want to see. You can also select
All Categories.
This field depends on the logs received by Vantage Report from the
selected ZyXEL device. Select what type of log entries you want to
see. You can also select All.
Severity ranking follows RFC 3164 of the SYSLOG protocol and is
defined as follows.
• Emergent - System is unusable
• Alert - Action must be taken immediately
• Critical - Critical conditions
• Error - Error conditions
• Warning - Warning conditions
• Notice - Normal but significant condition
• Info - Informational messages
• Debug - Debug-level messages
Select this to display logs with the domain name of hosts instead of
their IP addresses. If you select this and Vantage Report does not find
the domain name of a host, it will display the IP address. This feature
might increase the amount of time it takes to display log entries,
however.
This field is disabled if Category is All Categories. Select this if you
want to use other search criteria to look at log entries.
Enter the source IP address in the event that generated the log entry.
Select the service whose log entries you want to see. If you select
[Custom Service], you have to specify the Protocol and Port too.
Enter the destination IP address in the event that generated the log
entry.
This field is enabled if Services is [Custom Service]. Select the
protocol whose log entries you want to see.
Chapter 13 Logs
529