Table of Contents
Advertisement
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
User's Manual
can be found in the
Bonus Pack
CD. Thanks for the
help of saving our earth.
This Easy Installation Guide x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
IEEE1394 Cable x 1 (for MK89-1394 only)
Bonus Pack CD x 1
Registration Card x 1
PART NO: 49.8B701.001
DOC. NO: MK89N-EG-E0308A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
Online
5. Connect ATX power cable back to connector PWR2.
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse connected. The
factory default setting is set to "Disable"(1-2), and you may enable this function by setting the jumper to
pin2-3.
1. JP14 Clear CMOS
Pin 1
1
1
Clear CMOS
Normal Operation
(default)
2. JP28 Keyboard/Mouse Wakeup Jumper
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
Pin 1
1
1
Enable
Disable
(Default)
Advertisement
Table of Contents
