Jp14 Clear Cmos; Jp28 Keyboard/Mouse Wakeup Jumper - AOpen AX45F-8 Max Easy Installation Manual

Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete Online
User's Manual can be found in the
Bonus Pack CD. Thanks for the
help of saving our earth.
User's Manual x1
Easy Installation Guide x1
EzRestore Guide x1
40-wire IDE Cable x1
80-wire IDE Cable x1
Floppy Disk Drive Cable x1
Serial ATA Cable x1
Serial ATA Power Cable x1
IEEE1394 Cable x1
USB 2.0 Cable x1
S/PDIF Cable x1
Registration Card x1
Bonus Pack CD x1
Norton Anti-Virus CD x1
Back Panel I/O Shield x1
PART NO: 49.8A301.E01
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse. The factory default
setting is "Disable" (1-2), and you may enable this function by setting the jumper to 2-3.
DOC. NO: AX45F8XMAX-EG-E0307B

1. JP14 Clear CMOS

Pin 1
1
1
Normal
Clear CMOS
(default)

2. JP28 Keyboard/Mouse Wakeup Jumper

Tip: When should I Clear CMOS?
1. Boot fails because of overclocking...
2. Forget password...
3. Troubleshooting...
Pin 1
1 1
Disable
Enable
(Default)