Table of Contents
Advertisement
Footswitch
Operation
Disconnecting
the Footswitch
Mini 4 Bar™ 2.0 User Manual Rev. 6
The included footswitch provides quick access to the preset colors, color change
programs, and triggering via the onboard microphone on the Mini 4 Bar™ 2.0. Please
see the chart, along with the set of instructions below for further explanation.
1.
Power on the fixture.
2.
Connect the footswitch to the Mini 4 Bar™ 2.0 via the 3-pin connection cable.
3.
Press pedal #1 (Preset) to activate control. When this is operating properly, the
LEDs on the Mini 4 Bar™ 2.0 will light white (first function on pedal #1).
Pedal
Sub-option
1
(Preset)
2
(Blackout)
1 & 2
Press both pedals
simultaneously
(Sound Active)
There is no need to modify any settings for the Mini 4 Bar™ 2.0 before connecting
the footswitch. It will operate properly in any mode.
Plug the master fixture in LAST!
In order to properly disconnect the footswitch, please follow these steps:
1.
Unplug the footswitch from the Mini 4 Bar™ 2.0.
2.
Turn the power to the fixture off (unplug the power cable).
3.
Turn the power to the fixture on again (plug in the power cable), and the fixture
will properly operate on any one of the 3 modes.
Function
1 x press
White
2 x press
Red
3 x press
Green
4 x press
Blue
5 x press
Yellow
6 x press
Magenta
7 x press
Cyan
Color change every second in a
8 x press
continuous loop
Color change every three seconds in a
9 x press
continuous loop
All LEDs off; press pedal 1 or pedals 1 &
1 x press
2 to re-enter active modes
Sound-active mode
Page 11 of 15
Advertisement
Table of Contents
