Automatic Speaker Setup (Audyssey Multeq ® ) - Integra DTR-6.9 Instruction Manual

First Time Setup—Continued
Automatic Speaker Setup
(Audyssey MultEQ
With the supplied calibrated microphone, Audyssey
MultEQ automatically determines the number of speakers
connected, their size for purposes of bass management,
optimum crossover frequencies to the subwoofer (if
present), and distances from the primary listening position.
Audyssey MultEQ then removes the distortion caused by
room acoustics by capturing room acoustical problems
over the listening area in both the frequency and time
domain. The result is clear, well-balanced sound for
everyone. Enabling Audyssey MultEQ allows you to
also use Audyssey Dynamic EQ
proper octave-to-octave balance at any volume level (see
page 100).
Before using this function, connect and position all of
your speakers.
Measurement Positions
To create a listening environment in your home theater
that all listeners will enjoy, Audyssey MultEQ takes
measurements at up to six positions within the listening
area.
■ 1st measurement position
This is the center position of your listening area, or
the listening position if there's only one listener.
−
■ 2nd
6th measurement positions
These are the other listening positions (i.e., the
places where the other listeners will sit). You can
measure up to six positions.
The following examples show some typical home theater
seating arrangements. Choose the one that best matches
yours, and position the microphone accordingly when
prompted.
TV
TV
TV
: listening area
48
®
)
TM
, which maintains the
TV TV
TV TV
TV TV
–
: listening position
Using Audyssey MultEQ
1
2, 10
3-8
Notes:
• If any of your speakers is 4 ohms, change the
"Speaker Impedance" setting before running the
automatic speaker setup (see page 44).
• If the AV receiver is muted, it will be unmuted auto-
matically when the automatic speaker setup starts.
• Automatic speaker setup cannot be performed
while a pair of headphones is connected.
• It takes about 15 minutes to complete the auto-
matic speaker setup for three positions. Total
measurement time varies depending on the num-
ber of positions and speakers.
• Do not disconnect the speaker setup microphone
during the automatic speaker setup, unless you
want to cancel the setup.
• Do not connect or disconnect any speakers during
the automatic speaker setup.
The onscreen setup menus appear only on a TV that
is connected to the HDMI OUT. If your TV is con-
nected to the composite video or S-Video MONI-
TOR OUT, or the COMPONENT VIDEO
MONITOR OUT, use the AV receiver's display
when changing settings.
1
Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
®