Integra DTR-6.9 Instruction Manual page 110

Advanced Setup—Continued
■ Control
This function allows
connected via HDMI to be controlled with the AV
receiver.
Disable:
Enable:
Notes:
• , which stands for Remote Interactive over
HDMI, is the name of the system control function
found on Integra/Onkyo components. The AV receiver
can be used with CEC (Consumer Electronics Con-
trol), which allows system control over HDMI and is
part of the HDMI standard. CEC provides interopera-
bility between various components, however, opera-
tion with components other than
components cannot be guaranteed.
• Set to when a connected piece of equipment
"Disable"
is not compatible or it is unclear whether the equip-
ment is compatible or not.
• If movement is unnatural when set to
the setting to
"Disable"
• Refer to the connected component's instruction man-
ual for details.
Power Control
To link the power functions of
components connected via HDMI, select "Enable".
Disable: Power Control disabled.
Enable: Power Control enabled.
Notes:
• The "Power Control"
above setting is set to "Enable".
"Control"
• HDMI power control only works with
patible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to "Enable", power consumption will
increase.
• When set to "Enable", regardless of whether the AV
receiver is On or on Standby, both audio and video
received by an HDMI input will be output by the
HDMI OUT for playback on the TV or other compo-
nent that's connected to the HDMI OUT.
• Refer to the connected component's instruction man-
ual for details.
TV Control
Set to "Enable" when you want to control the AV
receiver from an
nected to HDMI.
Disable: TV Control disabled.
Enable: TV Control enabled.
Notes:
• Set to when the TV is not compatible or
"Disable"
when it is unclear whether the TV is compatible or
not.
• The
"TV Control"
above "Control" and
set to "Enable".
110
-compatible components
disabled (default).
enabled.
-compatible
"Enable"
.
-compatible
setting can be set only when the
-compatible TV that is con-
setting can be set only when the
"Power Control" settings are both
• Refer to the connected component's instruction man-
ual for details.
Note:
After changing the settings of the
Control" , or
connected pieces of equipment and then turn on
again. Refer to the User's Manuals for all connected
pieces of equipment.
Network
These settings are for use with home automation equip-
ment and external controllers.
, change
-com-
"Control"
"TV Control" , turn off the power to all
,
"Power