Assembling And Attaching Brass Trim - Desa UNVENTED (VENT-FREE) PROPANE GAS FIREPLACE Owner's Operation And Installation Manual

INSTALLING
Continued
10

ASSEMBLING AND ATTACHING BRASS TRIM

Note: The instructions below show assembling and attaching brass trim to fire-
place. You cannot attach the brass trim as described below for built-in installation
(see page 13).
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates with set screws, and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 5.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim
(see Figure 5).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side brass
trim (see Figure 5).
6. While firmly holding edges of brass trim together, tighten both set screws on
the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
Side Brass Trim
Slot
Figure 5 - Assembling Brass Trim
8. Place the assembled trim onto fireplace cabinet. Attach to fireplace with brass
screws included in hardware package (see Figure 6).
Assembled
Brass Trim
Figure 6 - Attaching Brass Trim to Fireplace
Set Screws
Adjusting
Plate
Shim
Slot
Mitered Edge
Top Brass Trim
Screws
101969