Error Messages - Pioneer AVIC-D3 Operation Manual

MAN-AVIC-D3-EN.book Page 134 Monday, January 15, 2007 8:51 AM
Message
• No map data available on this
scale. Scaling up.
• No map data available on this
scale. Scaling down.
Failure in the memory recovery proc-
ess.
Memory navigation is presently not
possible.
The map data could not be stored.
Previous setting will be kept.
This function is not available with the
current map disc.
Failed to save to memory. Please re-
enter setting.

Error Messages

When problems occur with disc playback, an error message appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Centre.
The messages in "( )" will appear on the "Rear display".
Message Cause
Reading error Dirty
(ERROR-02-XX)
Scratched disc
The disc is loaded upside down
Mechanism error Electrical or mechanical
Region code error The disc does not have the same region
(DIFFERENT REGION number as the navigation system
DISC)
NON PLAYABLE DISC This type of disc cannot be played by the
navigation system
Thermal error The temperature of the navigation system is
(THERMAL PROTEC- outside of the normal operating range
TION IN MOTION)
Non-playable tracks Files that are protected by digital rights
are skipped. management.
(FILE SKIPPED)
134
When
When the scale that had been previ-
ously displayed cannot be displayed
for the following reasons:
• The disc was ejected and the sys-
tem was changed to the memory
navi mode.
• In the memory navi mode, the map
was scrolled to outside the memory
area. Or, the vehicle moved outside
of the memory area.
• The map was scrolled to areas not
stored on the DVD Map Disc. Or,
the vehicle moved to unrecorded
areas.
• The map was scrolled from unre-
corded areas to the memory area.
Or, the vehicle moved from unre-
corded areas to the memory area.
Failed to complete the recovery of the
memory area because the disc could
not be read for some reason, result-
ing in deletion of the memory.
Recovery was performed for the
memory area after failing to read the
disc data for some reason (The mem-
ory area that was previously set will
be recovered).
The current position is "areas not
stored on the DVD Map Disc" and an
attempt was made to zoom in to
make the scale 500 m or more.
The settings could not be saved for
some reason.
Action (See)
Clean disc.
Replace disc.
Check that the disc is loaded correctly.
Press the RESET button. (Refer to page 125
in this manual.)
Replace the DVD-Video with one bearing the
correct region number.
Replace the disc with one the navigation sys-
tem can play.
Wait until the unit's temperature returns to
within normal operating limits.
The protected files are skipped.
What to do
If the desired scale cannot be
selected, insert the DVD Map Disc
that contains that area and then
change the scale.
• Clean the disc.
• Clean the DVD drive.
• Consult the Pioneer Local dealer if
this message persists.
• Clean the disc.
• Clean the DVD drive.
• Consult the Pioneer Local dealer if
this message persists.
Zoom in again after the vehicle
moves into an area stored on the
DVD Map Disc.
Or, replace the DVD Map Disc and
try to zoom in again.
• Retry.
• Consult the Pioneer Local dealer if
this message persists.