The Dmz Screen; The Sessions Screen - ZyXEL Communications LTE6100 User Manual

8.3 The DMZ Screen

Use this page to set the IP address of your network DMZ (if you have one) for the LTE Device. All
incoming packets received by this LTE Device's WAN interface will be forwarded to the default
server you set.
Click Network Setting > NAT > DMZ to display the following screen.
Note: The configuration you set in this screen takes priority than the Network Setting >
NAT > Port Forwarding screen.
Figure 33 Network Setting > NAT > DMZ
The following table describes the fields in this screen.
Table 23 Network Setting > NAT > DMZ
LABEL
Default Server
Address
Apply
Cancel

8.4 The Sessions Screen

Use the Sessions screen to limit the number of concurrent NAT sessions each client can use.
Click Network Setting > NAT > Sessions to display the following screen.
Figure 34 Network Setting > NAT > Sessions
LTE6100 User's Guide
DESCRIPTION
Enter the IP address of your network DMZ host, if you have one. 0.0.0.0 means this feature
is disabled.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
Chapter 8 Network Address Translation (NAT)
63