Casio Aculaser M2 User Manual page 21

■ Configuring End Measure Settings
End Measure settings specify the number of
measures (up to a maximum of 16) in the
phrase. Phrase recording stops automatically
when it reaches the number of measures
specified by the End Measure setting.
Auto : No number of measures is specified.
The number of measures where
phrase recording was stopped is
applied automatically.
1 to 16 : Phrase recording stops when it
reaches the specified number of
measures.
bm
• Pressing the (SYS SETTING) button will display a
menu of the detailed settings shown below. Use the
dt down (w) and ek up (q) buttons to select a
parameter and then use the
buttons to change its setting.
Menu Description
Guide Beat Guide tone (Guide
Beat). Specifies
whether or not a count
tone is sounded during
phrase recording and/
or record standby.
Precount Precount (Precount).
Specifies the number
of measures of count.
HighReso/ High-resolution sound
Off Velo source (High Reso
Velocity) and off
velocity (Off Velocity).
Turning on this setting
records with both a
high-resolution sound
source and Off
velocity. However, the
maximum number of
measures that can be
recorded is halved
when this option is
turned on.
• Pressing the ep (EDIT) button will display a screen
for configuring Guide Beat (click), precount, and End
Measure beat settings.
Use the dt (w) and ek (q) buttons to select "Beat",
and then use the eo minus (–) and plus (+) buttons to
select a beat within the ranges of 2/4 to 8/4, or 2/8 to
16/8.
eo minus (–) and plus (+)
Setting
Range
Off, On
Off
1:1 measure,
2:2 measures
Off, On
Recording and Playing Back Phrases
2.
Start recording.
• For details about how to do this, see "Starting and
Stopping Recording" in "Operations Common to All
Modes" (page E-12).
• Recording is performed as a Zone 1 stage setup
phrase. For details about zones, see the separate
"Tutorial".
3.
After you finish recording, save the data as
described below.
• For details about how to do this, see "Saving Data" in
"Operations Common to All Modes" (page E-11).
• The message "Memory Full" will appear on the
display when recording is not possible because there
is not enough memory capacity available. If this
happens, record a different phrase that does not take
up so much memory.
• For information about deleting data you saved, see
page E-28.
■ Saving a Phrase to an External Device
• USB flash drive (page E-32)
• Computer (page E-37)
E-19