ZyXEL Communications Omni 56K USB Lite User Manual page 62

Omni 56K USB Lite
COMMAND BIT
S19=
NOTE: Only speeds up to S20=15 are supported by auto-speed detection.
S21= Bit
0
1-2
3
4
5
5-16
DEC HEX
dec hex Modem connection mode, same.
0-99 0- Setting value as 'AT&Nn' command.
63
dec hex Bit-mapped register.
0 0 Maintain a non-error control connection when
modem error control handshake fails (default).
1 1 Drop connection when modem error control
handshake fails.
0 0 Speaker is always OFF.
2 2 Speaker is ON until carrier is detected. (Default)
4 4 Speaker is always ON.
6 6 Speaker is ON after last digit is dialed out until
carrier is detected.
0 0 DSR is always ON (default).
8 8 According to CCITT (see also S44.4, S41.5).
0 0 CD is always ON.
16 10 CD tracks presence of data carrier (see also
S38.3) (default).
0 0 CTS follows RTS in synchronous mode.
Response delay set in S26.
32 20 Ignore RTS (CTS always ON) in synchronous
mode. (Default)
FUNCTION AND DESCRIPTION REF.
+000/&Nn
+178
*E0
*E1
M0
M1*
M2
M3
&S0
&S1
&C0
&C1
&R0
&R1
Command Sets