Clock/Calendar - Honeywell Lynx Plus Series User Manual

USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS

Clock/Calendar

Your system can display the current time (see your installer). The date is not displayed, but has an
internal function. The system must be disarmed.
To set the time and date:
The system will enter the Voice Prompt Calendar Setting mode.
any time to repeat a voice prompt.
NOTES: (1) Clock-Setting mode automatically ends if no keys are pressed for one minute.
(2) It is not possible to enter the real time clock programming mode from a wireless keypad
(3) Pressing any key on a wireless (RF) keypad terminates Clock/Calendar setup.
(4) It is not possible to enter the real time clock programming mode when either FC or CA is
displayed on the display.
1. "Set Time" will be displayed and the system will announce, "Enter two-digit hour, press ADD to
accept, ESCAPE to quit".
8: P
Hour PM
Hour (The current hour will be displayed with the A or P indication.)
Enter the 2-digit hour (i.e., 01-12).
Press [ADD] to accept the entry and continue to the AM/PM selection.
Press [ESCAPE] to exit Clock/Calendar mode (keypad beeps 4 times).
2. The system will announce, "Enter one for PM, zero for AM, press ADD to accept, ESCAPE to quit".
8: P
Hour PM
AM/PM
Enter 1 for PM or 0 for AM.
Press [ADD] to accept the entry and continue to the minute selection.
Press [ESCAPE] to back up to hour selection.
3. The system will announce, "Enter two-digit minute, press ADD to accept, ESCAPE to quit".
: 41
Minutes
Minute
Enter the 2-digit minute (i.e., 00-59).
Press [ADD] to accept the entry and continue to the month selection.
Press [ESCAPE] to back up to AM/PM selection.
+ FUNCTION + [63]
Master user code or
Installer Code
(The AM/PM setting will display A or P.)
(The current minute will display.)
– 30 –
The [#] key can be pressed at