Honeywell Lynx Plus Series User Manual page 33

Event Identifier
xid
Enter a 1-digit schedule action. (x = event identifier)
Event Identifier
NOTES: 1. See Table 1 for an explanation of each entry of the event identifier.
Selections
0 = Empty - no event scheduled (or schedule temporarily disabled).
1 = X10 Device
2 = Latch Key Report
3 = Automatic Stay Arming or Scheduled Stary Arming (LynxSIA Plus)
4 = Reminder Announcements
5 = Alarm Clock
[*] = Accept entry and continue
[#] = Return to previous prompt
Begin Time (hour)
:Ab
xx
Enter a two-digit begin hour. (xx = begin hour)
Begin Hour AM
Note: 1. To enter the hour 3, press "0" followed by "3".
Selections
00 to 12
[*] = Accept entry and continue
[#] = Return to previous prompt
Begin Time (AM/PM)
xx:Ab
Enter a selection for AM or PM. (xx = begin hour)
Begin Hour AM
Selections
0 = AM
1 = PM
[*] = Accept entry and continue
[#] = Return to previous prompt
Begin Time (minute)
b:xx
Enter a two-digit schedule begin time (minute) (xx = begin minute)
Begin time(min)
Selections
00-59 (minute)
[*] = Accept entry and continue
[#] = Return to previous prompt
2. If "Follow me" reminder telephone number is programmed, the reminder
announcement is also delivered to that number.
3. If "0" is entered, and accepted by deptessing [*], tthe keypad will beep four
times and return to the Schedule Number prompt and the schedule number
will be advanced.
2. When programming schedule number 7 and 8, do not program turn on/off to
occur within the same 1-hour period. This will prevent this random feature from
causing a reversal of the on/off times.
– 33 –
USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS
Scheduling User Interface