Operation And Maintenance - Fujitsu ETERNUS DX80 S2 Manual

Monitoring Setup
S T E P
Perform the ETERNUS DX Disk storage system monitoring setup if required.
Notification of the ETERNUS DX Disk storage system problems as they occur is possible if the event notification
●
method and level have been set.
If remote support is required, the ETERNUS DX Disk storage system needs to be set to notify the remote support
●
center of failures.
Point
-Installation- "5.2 ETERNUS DX Disk Storage System Monitoring Setup"
Server Connection
S T E P
Perform the settings required to connect to the server and install the required drivers. Perform the settings required
for network devices connecting the server and the ETERNUS DX Disk storage system.
After the server connection setup, confirm that the volumes in the ETERNUS DX Disk storage system can be
recognized by the server.
All necessary settings are complete, and the ETERNUS DX Disk storage system is now ready for normal operation.
-Installation- "5.4 Server Connection Setup"
●
-Server Connection-
●

Operation and Maintenance

Status check
The status of the ETERNUS DX Disk storage system should be regularly monitored by checking the LEDs and using ETERNUS Web
GUI.
Data backup
Important data should be regularly backed up to a tape drive or similar device as a precaution against system failures.
Maintenance support period
The standard maintenance support period for ETERNUS DX Disk storage system is five years from the date of purchase, or is
defined in your service level agreement (SLA). Contact your sales representative for details if you prefer to extend the period.
-Operation- "4.2 Monitoring ETERNUS DX Disk Storage System Status"
●
-Operation- "6.1 Periodic Backup"
●
-Operation- "6.4 Maintenance Service"
●
Remote support allows prompt detection and resolution of trouble.
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
16
P3AM-4872-11EN