Hisense LCD3703EU User Manual page 12

Using the TV features
Select channels by [CH+/CH-]
You can also use[CH+ / CH-] to select channels.
number decrease.
Select channels by numbers
To select a channel : Press the channel numbers in series to select channel directly.
For example, to seclect channel 120,
then press the button 2, 12 will display, press the button zero, you can enjoy the program of channel 120.
NOTE:
1) When you changing the channel, the sound state graphics can be displayed below the channel number. There
are 3 sound states in this TV. If the sound is mono, the graphics is
If the sound is NICAM dual I/II, the graphics is
Which indicate preset of picture system and sound system.
2) When you changing the channel, the sound of current channel will be firstly changed to stereo or NICAM dual I
according to the sound state of current channel. You can press the I/II button on the remote control to change
current sound type.
Adjust Volume
When menu is not displayed on the screen, press
Use [Recall] button
Power ON/OFF
Press the [ Recall ] button repeatedly to alternate between the present channel and the previous channel.
Display channel number
Press [Display] button to display the present channel number, but it will also disappear 3 seconds after your pressing.
Select picture modes
You can select the picture mode from among three preset modes and one user-set
mode. Press the [ P.mode ] button repeatedly to select the desired picture mode.
Select sound modes
You can select the sound mode from among three preset modes and one user-set
mode. Press the [ S.mode ] button repeatedly to select the desired sound mode.
Use [Still] button
Press the [ Still ] button to snapshot the present picture, and press again to return to normal watching.
Use [ Zoom ] button
Press the [ Zoom ] button to adjust the screen aspect ratio and zoom ratio
Mute function
Press [ Mute ] button repeatedly to switch between mute and unmute mode.
[CH+] i ndicates channel number increase;
Press the button 1, and 1 will display on the top right corner of the screen,
. There are two symbol at right of the sound state graphics,
[VOL+ or VOL-]
- 10-
[CH-]
, If the sound is stereo, the graphics is
to adjust the volume.
indicates channel
Normal
User
Soft
Bright
Speech
Nomal
User
Music