Unpacking And Installation; Unpacking; Handling Notes - Star Micronics SP317 Installation Manual

1. UNPACKING AND INSTALLATION

1-1. Unpacking

After unpacking the unit, check that all the necessary accessories are included in
the package.

1-2. Handling Notes

1. Install the unit on a stand or table which has a flat, even surface.
2. Do not connect the AC power plug to the same outlet used for other electrical
noise generating devices (such as an electrical motor, etc.)
IMPORTANT!
Install the printer near an easily accessible socket-outlet.
3. Be careful not to drop paper clips, pins or other foreign objects into the unit
as these could cause the printer to malfunction.
4. When cleaning the outer surface of the unit, wipe away dirt, foreign matter,
etc., with a soft cloth, soaked in a neutral detergent.
5. Do not attempt to print when the paper or ribbon cartridge are not loaded in
the printer as this could damage the print head.
6. Use only roll paper that is not glued to the core.
7. Do not open the front cover while printing (this is interpreted as a mechanical
error and the printer will stop).
Fig. 1-1 Unpacking (SP317)
– 2 –
Ø28mm Ø28mm
Ferrite core
(E.U. only)
Fastener
(E.U. only)