Removing A Module; Power-On The Sensor; Powering Off The Sensor - McAfee IIP-M80K-ISAA - Network Security Platform M-8000 Product Manual

McAfee® IntruShield® IPS 4.1
M-8000 Sensor Product Guide
Figure 7: Module in Monitoring port

Removing a module

If you are removing a module, follow these steps:
1
2
3
4

Power-on the sensor

Warning:
in a rack, made all necessary network connections, and connected the power cable
to the power supply.
Connect the power cable to the sensor power supply.
Connect the power cable to a power source.
Note:
described in Installing a power supply. For true redundant operation with the
optional redundant power supply, McAfee recommends that you plug each supply
into a different power circuit.
The M-8000 sensor has no power switch. The sensor powers on as soon as one of its
power cables is connected to a power source.

Powering off the sensor

McAfee recommends that you use the shutdown CLI command to halt the sensor
before powering it down. For more information on CLI commands, see
Configuration Guide—using CLI
Disconnect the network fiber-optic cable from the module.
Release the module from the slot by pulling the bail clasp out of its locked
position.
Slide the module out of the slot.
Insert the module plug into the module optical bore for protection.
Do not attempt to power on the sensor until you have installed the sensor
If you are installing a redundant power supply, you should install it as
.
16
Setting up an M-8000
Power-on the sensor
Sensor