Using The Redundant Power Supply; Installing The Power Supply - McAfee IIP-M80K-ISAA - Network Security Platform M-8000 Product Manual

McAfee® IntruShield® IPS 4.1
M-8000 Sensor Product Guide
Figure 2: Rail release latch

Using the redundant power supply

A basic configuration of the M-8000 includes one hot swappable supply. You may
install a second hot-swappable power supply (purchased separately from McAfee) for
redundancy.
Each of these modules has one handle for insertion or extraction from the unit as well
as a release latch.
Figure 3: Power supply units

Installing the power supply

To install a power supply in the M-8000:
1
2
3
4
Unpack the power supply from its shipping carton.
Remove the faceplate panel covering the power supply slot.
The faceplate panel should remain in place unless a power supply is in
Note:
the power supply slot.
Do not operate the sensor without the faceplate panel in place.
Place the power supply in the slot with the cable outlet facing front and on the
left side of the faceplate.
Using the redundant power supply
12
Setting up an M-8000