Front Panel Leds - McAfee IIP-M80K-ISAA - Network Security Platform M-8000 Product Manual

McAfee® IntruShield® IPS 4.1
M-8000 Sensor Product Guide
11
12
The M-8000 does not have internal taps; it must be used with a third-party external
tap to run in tapped mode.

Front panel LEDs

The front panel LEDs provide status information for the health of the sensor and the
activity on its ports. The following table describes the M-8000 front panel LEDs.
Pwr A (Power A)
Pwr B (Power B)
Note: If a power supply is not present, both green and amber LEDs are off.
Management Port Speed
Management Port Link
Sys
Fan
Temp
Flash
Two Power Supplies—B (optional, purchased separately). Power supply B is a hot-
swappable, redundant power supply. This power supply also uses a standard
IEC320-C13 port, and you can use the McAfee-provided cable or acquire one
that meets your specific needs.
Two RJ-45 10/100/1000 Interconnect ports,
sensor to the secondary sensor.
LED
Green
Amber
Green
Amber
Green
Amber
Off
Green
Off
Green
Amber
Green
Amber
Green
Amber
Green
Off
which are used to connect the primary
Status
Power Supply A is functioning.
Power Supply A is not functioning.
Power Supply B is functioning.
Power Supply B is not functioning.
The port speed is 1000 Mbps.
The port speed is 100 Mbps.
The port speed is 10 Mbps.
The link is connected.
The link is disconnected.
Sensor is operating.
Sensor is booting. (It could also
indicate a system failure.)
All three fans are operating.
One or more of the fans has failed.
Inlet air temperature measured inside
chassis is normal. (Chassis
temperature OK.)
Inlet air temperature measured inside
chassis is too hot. (Chassis
temperature too hot.)
Activity on external compact flash.
(For example, the Fail-Open
Controller has been inserted.)
No activity on external compact flash.
5
Overview
M-8000 physical description
Description