McAfee
This Quick Start Guide explains how to quickly set up and activate your McAfee
Security Platform [formerly McAfee
If you are setting up your Sensor in SPAN or Tap mode, see the M-6050 Product
Guide for cabling instructions.
All product documentation referenced in this Quick Start Guide is found on the McAfee
Service Portal.
The Sensor front panel
1
Power supply A (included)
2
Power supply B (optional; sold separately)
3
RS-232C Control port (1)
4
RS-232C Auxiliary port (1)
5
RJ-11 Fail-Open Control ports (8)
Cabling the Sensor's XFP (10 Gigabit Small Form-factor Pluggable) and SFP (Small
Form-factor Pluggable) Gigabit Ethernet Monitoring ports for in-line mode enables you to
configure the Sensor to drop attacks before they reach their target.
Sensor setup overview
This section explains how to position and cable the various ports of your Sensor. This section
also briefly explains how to install the Manager and then add the Sensor to the Manager,
and verify that you have successfully established communication between the Sensor and
the Manager.
M-6050 Sensor Quick Start Guide
Network Security Platform
®
®
IntruShield
®
] M-6050 Sensor in in-line mode.
6
SFP Gigabit Ethernet Monitoring ports (8)
7
XFP 10 Gigabit Ethernet Monitoring ports (8)
8
Compact Flash port (1)
9
RJ-45 Response port (1)
10
10/100/1000 Management port (1)
Revision A
Network
®
1