Embroidery Settings; Machine Information - Pfaff cvreative 3.0 Owner's Manual

Embroidery settings

Presser foot height
Adjust the height of the presser foot in Embroidery
stitch-out mode. Use the + and - icons to either raise or
lower the height of the presser foot.
Some embroideries may build up under the presser
foot. If there is not enough space between the presser
foot and the embroidery, the top thread will form
loops on the underside of the embroidery. Increase the
presser foot height in small steps until the embroidery
moves freely under the presser foot.
Note: Since the Dynamic Spring Foot 6D (optional 820991-
096) measures the fabric thickness, the option to adjust
presser foot height in embroidery is only available if Dynamic
Spring Foot 6D for embroidery is deselected.
Dynamic spring foot 6D
When embroidering, use the optional Dynamic spring
foot 6D (part number 820991-096, available at your
authorized PFAFF dealer). Activate the "Dynamic
®
spring foot 6D" function.
If using another type of embroidery foot, e.g.
Embroidery/Sensormatic free-motion foot 6A,
deactivate Dynamic spring foot 6D in the settings menu.
Cut jump stitches
Your machine features the automatic function Cut jump
stitches. This function saves you time trimming after
the embroidery is completed. When Cut jump stitches
is selected your machine will trim the top jump stitch
thread and pull the thread end to the underside of the
fabric as you embroider. When deselected, the machine
will stop after a few stitches in every color change to let
you cut the threads manually.
Note: Your machine will also cut the thread after you have
changed to a new color. Hold the thread end when you start
embroidering again, so that you can easily remove the thread
end when cut.
Designs marked with this symbol are programmed
for Cut jump stitches. Cut jump stitches commands
can be added to any design using the software package
downloaded via PFAFF
Thread snips for embroidery
Thread snips for embroidery is automatically activated
by default. This function automatically cuts the threads

Machine information

The machine information tab contains the software
version, memory usage in machine and license
information.
website (see page 2:12).
®
Presser foot
height control
3:5