Advertisement
Interoperability Software Versions
The following gateway version was tested for interoperability:
System Description: Quintum Tenor AS
Hardware Version: P106-02-00
Firmware Version: P106-12-00
Overview of Procedure
To provide its functionality, the Quintum Tenor AS must be connected to the internal LAN (a 100 Mbps
connection is recommended) and from 1-4 PSTN analog phone lines.
The Quintum Tenor AS is primarily configured using a java configuration program. The program must
be installed to configure and manage the gateway.
The basic steps for installation and configuration are:
1. Unpack the Quintum Tenor AS.
2. Mount the Quintum Tenor AS.
3. Connect cables.
4. Power up the Quintum Tenor AS.
5. Set a DHCP IP address reservation for the Quintum Tenor AS based on its MAC address.
6. Run the initial configuration wizard.
7. Configure the UC server to use the Quintum Tenor AS.
Note: Please see the instructions provided by Quintum for steps 1 to 4, and for information about running
and configuring the gateway.
The rest of this document provides instructions for steps 5 to 7, which allow you to configure the
Quintum Tenor AS for operation with the UC server.
Address Reservation
By default, the gateway is configured to use an IP address assigned by DHCP. The gateway can also be
configured to use a static IP address. For routing calls out from the UC server, the Quintum Tenor AS
must have an IP address that does not change.
3
Advertisement
