Batteries - Bounty Hunter Sharp Shooter II Owner's Manual

BATTERIES

IMPORTANT:
Always use ALKALINE batteries for optimal performance.
Always remove the batteries for prolonged storage.
CHECK THE BATTERIES if your detector exhibits any of the following
symptoms:
G
The unit does not turn on.
1
G
Low speaker volume.
2
G
Unable to tune detector with the discriminate knob.
3
The Low Battery indicator will come on and stay on whenever the
batteries need replacing. It should flash momentarily when the Power
Switch is turned on.
IMPORTANT:
Your Sharp Shooter II metal detector requires two 9-Volt
ALKALINE batteries.
Follow these steps to install the batteries.
G
Carefully remove the battery compartment door by pressing the release
1
clip on the right side of the door.
G
Snap one battery onto each of the terminals and place the batteries
2
inside the compartment.
G
Replace the compartment door by carefully inserting opposite side of clip first.
3
Then press down on
clip side until battery
door snaps into place.
Release
Clip
5