D-Link ShareCenter Pulse DNS-320 User Manual page 10

D-Link ShareCenter Pulse User Manual
5. Connect an Ethernet cable to the available Ethernet port. This cable should 6. Connect the power adapter to the power receptacle.
connect the ShareCenter Pulse to your local network via a router or switch, or
directly to a computer for configuration.
Make sure to align the drive connector to the SATA connector on the bottom edge inside the drive bay of the ShareCenter Pulse. Gently push the drive in until it connects.
When a drive is inserted properly, you will feel it "seat" into the connector. Some hard drives that are thin or oddly shaped may need to be guided carefully into position. If a
drive is not properly seated, the light will not illuminate after powering on the device.
Page 10