Starting Triggerscan - LeCroy WaveMaster 8Zi Getting Started Manual

WaveMaster 8 Zi – Zi-A Oscilloscopes

Starting TriggerScan

After you have run the Trainer, the Trigger List displays a list of smart
trigger setups. You can add or remove trigger setups. You can also update
the selected smart trigger setup. Once you have made any changes to the
Trigger List, you are ready to start scanning.
1. Touch Trigger → Trigger Setup from the menu bar.
2. On the Trigger dialog, click the TriggerScan tab.
3. If you want to add a new trigger setup, touch the Trigger tab and set
the new trigger. Then, touch the Add New button to add the new
trigger to the Trigger List.
4. If you want to delete a trigger setup, highlight the setup in the
Trigger List and touch the Delete Selected button.
Note: If you want to delete all trigger setups in the Trigger List, touch the
Delete All button.
5. If you want to replace the selected trigger setup with the current
trigger setup, highlight the setup in the Trigger List and touch the
Update Selected button.
6. Once you have made any changes to the Trigger List, touch Start
Scan. The oscilloscope automatically sequences through all the
trigger setups.
PLEASE NOTE THE FOLLOWING:
 You can tune the dwell time that the oscilloscope will wait
before loading the next trigger setup using the Dwell Time
data entry field.
 If you have Persistence display mode enabled, all trigger
events are recorded on the display. Refer to the Persistence
Setup (on page 106) topic for instructions on enabling
Persistence display mode.
97
918893 RevA