Muting The Output Sound - Bosch PLE-SDT Installation And Operation Manual

Plena Easy Line SD Tuner BGM source
5.
6.
7.
8.
9.
10. Press the buttons |< – SKIP – >| (6) to select any track of the track sequence or keep the
11. The replay will stop after the track sequence has been replayed or when you press the
12. To restart the track sequence, first press the button
A track sequence will be not stored when:
–
–
–
8.2.5

Muting the output sound

To mute the audio output sound (outputs: 30, 31) of the track during replay:
1.
2.
Bosch Security Systems B.V.
keys (17, 20) (This is also necessary when all the files are in the ROOT directory without
folder).
– In this example, enter 1 as the folder number.
To memorize press the button PROG (9):
– The LCD (3) will show the track number (xxxx) flashing.
Select the number of the first track (xxxx) of the track sequence with the buttons |< –
SKIP – >| (6) or enter it with the remote control numerical keys (17, 20).
– For MP3 files in folders, please note that these files are not arranged consecutively
but that the first file in each folder is always number 1.
To memorize press the button PROG (9):
– The LCD (3) will show the next memory location number, e.g. "P–02".
Repeat the steps 3 up to 7 for all further tracks desired until the entire track sequence
has been programmed.
To start the track sequence, press the button >|| (10):
– The upper line of the LCD will show "MEM" (memory) and the track sequence will
be replayed.
corresponding button pressed to activate the fast forward/reverse function within a
track.
button (8).
PROG (9) and then the button >|| (10).
you change from source (USB / SD / TUNER).
you press the button
you switch off the source unit (button 1).
Press the button (4):
– The LCD lower line will show MUTE flashing continuously when the mute function is
activated.
To reactivate the sound, press the button
– The LCD (3) upper line will show "MUTE OFF" for 3 seconds.
Installation and Operation manual
(8) in the programming mode.
(4) once again:
Operation | en
(8), then press the button
PLE-SDT_OM | V1.0 | 2012.02
23