Table of Contents
Advertisement
Plena Easy Line SD Tuner BGM source
7
Configuration
Switch on the unit with the POWER switch (1).
Figure 7.1 Front view
Figure 7.2 Rear view
7.1
FM tuner
7.1.1
Tuner audio output level control
1.
2.
7.1.2
Preset radio frequency programming
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems B.V.
Set the TUNER (26) audio output level control to the required amplifier input level.
–
The audio output level could be set between mute and 1.5 Vrms.
–
It is advised to set the control in the upper mid position, at start.
Refer to Section 11 Technical Data for audio output level.
Select the FM tuner source with the remote control button USB/SD/-TUNER (39).
–
The green LED TUNER (21) will light up.
Select the required FM radio frequency with the buttons |< (19) and >| (22).
Press the button PROG (23).
–
The FM tuner LCD (16) shows the preset number (CHxx) flashing during this
process.
–
Maximum 30 presets could be stored.
Press a button 1 to 10/0 (17) for preset position 1 to 10. Or:
Press the button 1 to 10/0 (17) following by the button +10 (20) for preset positions 11
to 30.
–
1st actuation of button +10: Preset 11 up to 19.
–
2nd actuation of button +10: Preset 20 up to 30.
Press the button PROG (23) again to store the selected FM radio frequency as a preset.
Refer to Section 8.3.2 Preset FM radio frequency selection.
Installation and Operation manual
Configuration | en
17
PLE-SDT_OM | V1.0 | 2012.02
Hide quick links:
Advertisement
Table of Contents
