Operation; Remote Control - Bosch PLE-SDT Installation And Operation Manual

Plena Easy Line SD Tuner BGM source
8

Operation

Switch on the source unit with the POWER switch (1). The USB/SD LCD (3) will show
"Version x.x" and the FM tuner LCD (16) will show the last used FM radio frequency and or
preset radio frequency. First the USB/SD source will read the USB flash memory on the front
(2) and rear (25). If no USB flash memory device has been connected, the USB/SD source
LCD (3) will show "NO USB" and it will continue to read the SD/MMC (15) memory. If no SD
memory card has been inserted, the USB/SD source LCD will show "NO CARD".
NOTICE!
The unit will play FAT32 formatted SDHC card and USB sticks. Some rare occurring partition
tables will not be played despite FAT32 formatting. Most standard available USB flash memory
and SD card will be played. If a card is not played, please check with a different type of card
whether the unit is faulty or whether a non compliant format is used.
8.1

Remote control

When you press a button on the remote control, always direct the remote control IR
transmitter lens (41) towards the IR receiver lens (18) of the source unit. There must be no
obstacles between the remote control and the IR receiver lens.
The button functions of the remote control are identical to the buttons on the source unit
front side. Refer to Section 3.5.3 Remote control and the following sections.
Figure 8.1 Remote control
1.
2.
NOTICE!
If the range of the remote control decreases, the batteries are exhausted and must be
replaced. Refer to Section 5.3 Remote control.
Bosch Security Systems B.V.
First select the source to be controlled by the remote control with the button USB/SD/-
TUNER (39):
– The green LED USB/SD (12) or TUNER (21) will light up of the selected unit source.
Continue with Section 8.2 USB/SD source or with Section 8.3 FM tuner.
Installation and Operation manual
Operation | en 19
PLE-SDT_OM | V1.0 | 2012.02