Led Matrix Display; Led Matrix Boot Stage And Runtime Display - Cisco ASR 9001-S Overview And Reference Manual

Route Processor Card
Table 2-2 RP Discrete LED Display Definitions (continued)
Indicator (Label) Color
Synchronization Green
(SYNC)
Amber
Off
(Default after reset)
Internal Solid Green
State Hard Disk
Drive (SSD)
Off
(Default after reset)
FC Fault Amber
Off
(Default after reset)
GPS Green
Off
(Default after reset)

LED Matrix Display

The LED matrix displays one row of four characters. The matrix becomes active when the CPU powers
on and displays the stages of the boot process, as well as displaying runtime information during normal
operation. If there are CAN Bus Controller problems, error messages are displayed.

LED Matrix Boot Stage and Runtime Display

Table 2-3
Table 2-4
information.
Not all of these messages are seen during a successful boot up process because the screen is updated too
quickly for the message to be visible. A failure detected during the boot up process results in the message
remaining visible indicating the stage where the boot up process stopped. When possible, the RSP/RP
card logs the failure information and reboots.
Table 2-3
LED Matrix Display
INIT
BOOT
IMEM
IGEN
ICBC
Cisco ASR 9000 Series Aggregation Services Router Overview and Reference Guide
2-12
Description
System timing is synchronized to an external timing source including
IEEE 1588.
System timing is free running.
LED never turns off.
Internal Solid State Hard Disk Drive (SSD0) is busy/active. The LED is
driven by the SSD controller.
Internal Solid State Hard Disk Drive is not busy/active.
A fault has occurred on any or all of the FC cards installed. This LED will
be on during the boot phase of the FC.
FC cards are booted up and ready.
GPS interface provisioned and ports are turned on. ToD, 1 PPS, 10 Mhz are
all valid.
Either the interface is not provisioned, or the ports are not turned on. ToD,
1 PPS, and 10 Mhz are not valid.
describes the RSP LED matrix displays of the stages of the boot process and runtime information.
describes the RSP-440 and RP LED matrix displays of the stages of the boot process and runtime
RSP LED Matrix Boot Stage and Runtime Display
Description
Card is inserted and microcontroller is initialized.
Card is powered on and CPU is booting.
Starting initialization of memory.
Starting initialization of card.
Initializing communication with the microcontroller.
Chapter 2 Functional Description
OL-17501-09