Kenmore 795.6800 Series Use & Care Manual page 17

Insert the Decorative Screw into the outer hole on the right
side of the housing. Attach cover on the right side. Cover
is force-fitted.
REATTACHING THE DOORS
Place the freezer door down over the Hinge Pin on the
Middle Hinge Pin Bracket.
Place the Upper Hinge Pin on top of the freezer door
and line up the Upper Hinge with holes on top of the
refrigerator. Use the three bolts to replace the Hinge.
Tighten the bolts. Force-fit Top Hinge Cover over Top
Hinge.
Replace cover on the top left side of the refrigerator to
the right top to cover the holes. Cover is also force-fitted.
Cover (on top of
refrigerator)
Decorative
Screw
17
REFRIGERATOR INSTALLATION
Rotate the handles. The freezer handle will move to the
refrigerator door, and the refrigerator handle will move to
freezer door.
NOTE: Make sure that the handle screw holes are facing
the right side of the door.
B
Install the Freezer handle by adjusting the handle
footprints to fit mounting fasteners. Tighten the set screws
with a 3/32" hex wrench.
Install the two screws under the handle with a screwdriver.
A
B
A
Screw
Handle
Wrench
Handle
Screws