Connecting The Server To The Mains - Fujitsu PRIMERGY TX100 S3 Operating Manual

Two additional USB connectors are located on the front of the server (see figure
5 on page 52).
Connecting the monitor
Ê Connect the monitor to the video connector of the server (see figure
page 46).
Ê Connect the power cable of the monitor to a grounded mains outlet of the in-
house mains.
V
CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
5.4

Connecting the server to the mains

The server is equipped with an integrated power supply unit.
V
CAUTION!
The server is automatically set to a mains voltage in the range 100 V -
240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cord to the server power supply unit.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
TX100 S3
Operating Manual
Hardware installation
2 on
47