National Security Systems Security System Owner's Manual page 35

Turn the Entire System On Without Delays
• You can use this Command Menu function to turn on the entire system, both perimeter
and interior, without delays. You may use this function in all of the areas or some of the
areas where your passcode has authority. If there are areas already turned on, this
function turns on all areas that are off without changing the status of the areas that are
already on.
1. Press the ESC/MENU key to enter the Command Menu.
2. Press the NEXT key until the MASTER ARM INST ? function is displayed. Press
ENT. Your system may require a passcode before allowing you to access this
function. ENTER PASSCODE appears in the display. Enter your passcode and press
ENT.
3. The display shows ARM INSTANT ALL? Press ENT. The command center displays
the armed idle text for the area you are in. The actual number of areas you may turn
on is limited by command center scope and/or your authority level. For example, if
you have authority to arm all 8 areas but the scope of the command center you're
using is limited to areas 1, 2, and 5, then you will only be able to turn on areas 1, 2,
and 5.
4. To arm selected areas instantly, press NEXT at the MASTER ARM INST ?
prompt. Continue to press NEXT until you find the area you wish to arm.
Press ENT.