Table of Contents
Advertisement
VIEW LOG ?
Description
•
Use this function to review events in your system at your command center. Reviewing
past events may help you identify problems. Viewing events does not require any
additional equipment since the information is displayed at your command center. Events
are stored in the panel's memory in order of occurrence and tagged with the date and
time.
Using View Log:
1.
Ensure your command center is at idle text.
2.
Press 9 and then 9 again and then ENT.
3. VIEW LOG ? displays. Press ENT.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to
initiate this function. Press the MENU key to enter the Command Menu, then
press NEXT repeatedly until you reach the VIEW LOG ? prompt. Press ENT.
4. ENTER START DATE displays.
•
To view part of the log, enter the date (month and day, MMDD) at which you
wish to start the review. Press ENT.
•
To view the entire log from the newest event, press ENT without entering a
start date. The date and time of the event will display. Press NEXT to view
the description of the prior event, or press PREV to view the description of
the prior event. Press PREV again to view the date and time of the previous
event.
•
Continue to press PREV to view event descriptions and the date and time of
each event.
Note: When using the NEXT key to view the log, the date and time of the event are
displayed first, followed by the description of the event. An event description
may take up 2 displays.
5. Continue pressing NEXT to view the rest of the log. When you reach the end of
the log, END OF LOG displays.
6. Press ESC to return to idle text.
Advertisement
Table of Contents
