Lcd Panel; Reassembly - NEC VERSA UltraLite Service And Reference Manual

LCD Panel

Remove the LCD panel as follows.
Save any open files, exit Windows, turn off notebook power, close the LCD panel, unplug
1.
the power cable, and disconnect any peripheral devices.
On the back of the notebook, remove the adhesive backed foot and screw from each side of
2.
the battery bay. The two screws partially secure the LCD panel to the base.
Remove the secondary battery, hard drive, keyboard, top cover assembly, and main board.
3.
Remove the screw and cable clamp securing the LCD panel cable in place on the base (see
4.
the preceding figure "Removing the processor assembly and communication board" for
clamp and cable locations).
On each side, remove the screw securing the LCD panel hinge bracket to the base (the
5.
following figure shows the left side hinge bracket and screw, the right side is similar).
Remove the LCD panel and place in a safe place.
6.
A – Bracket Screw (left side)

Reassembly

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and
screws are returned to their correct positions.
Check that the power switch on the side of the notebook slides smoothly and does not bind. If it
does not slide smoothly, remove the top cover assembly (see "Top Cover Assembly" earlier in
this section for removal procedures). Reseat the top cover assembly, ensuring that the power
switch is against the side of the base while snapping the top cover assembly in place.
Removing the LCD panel screw
B – LCD Panel Hinge Bracket (left side)
Disassembly and Reassembly 3-13