NEC S2900 User Manual page 135

Set the network property. For the network control parts #0 and #1, the same values are set.
CONT#0/CONT#1
SELECT
COPY1->0/COPY0->1
(1) IP Property
IP Address
Subnetmask
Gateway Address
SET
(2) Manager Property
Trap Interval Time(s)
iSM Valid
SNMP Valid
Community Name
0. 0.0.0.0
SNMP
TRAP
SCSI
THRESHOLD
SET
(3) SNMP Property
Unit Contact
Unit Name
Unit Location
Unit Info
Unit Event Filter
SET
Select the CONT whose settings are to be viewed.
After the selection, click SELECT to determine it.
Set the network properties having been set to 1 or 0 are set to either
all 0s or all 1s and save the values. The IP property is also saved.
LAN IP Address
LAN Subnetmask
LAN Gateway Address
Determines the IP property.
Set the interval for collecting information on SNMP trap in the range
of 3 – 60 seconds. (Default: 20 sec)
Makes iSM effective unconditionally (ON if checked).
Make accessible from iSM without manager registration
Makes SNMP effective (ON if checked).
Read permission for SNMP and community name of trap (default
value: public)
Registers accessible managers (up to 8).
Check this to make accessible from SNMP manager.
Check this to report SNMP trap.
Check this to make accessible from iSM.
Set the threshold of SNMP trap to be reported to registered
managers.
(Set 6 if not specified especially.)
Determine the Manager Property.
Contact on management (Default: NULL)
Name of agent management destination (Default: NULL)
Run browser update after modification
Unit installation location (Default: NULL)
Unit management information (Default: NULL)
Threshold of event level to be registered to event table (Default=6)
Determine the SNMP Property.
118