Round Hole Fitting Rail - NEC S2900 User Manual

1.2.2

Round Hole Fitting Rail

NOTE: Each rail has a rail support attached. When a rail is
installed on a rack with round holes, remove the rail support
from the rail.
19. Remove the rail support installed previously from each rail by removing four screws (two on
the front and the other two on the rear).
Remove
20. Loosen four flush screws at the rear side of the rail.
After loosening the screws, make sure that the moving part of the rail can slide smoothly.
NOTE: Do not remove the flush screws.
Remove
133