Filling Up The Bath - Bosch BC2600RA Owner's Manual

Filling Up the Bath

In order to run a warm bath, push the bath fill
button and open the hot water tap of the bath.
When the bath has reached the volume set
on the controller, an alarm sounds and the hot
water supply will stop automatically.
Once the bath fill is complete, please close
the tap as the water heater cannot operate
until this is done.
Set temperature.
3
Always check
(
temperature setting
before use.
Hot
Cold
Check the indicator lights.
Bath Fill
Priority Burner on
Temp.
Bath Fill temperature
Operating Instructions
To set the Bath Fill Volume:
4
Adjust bath fill
)
volume setting.
Press the Bath Fill button (the setting
will flash on the display) and adjust
with the setting buttons.
Volume
setting
Choose the bath fill volume setting from the
following options: 40 - 80 (In 20 litre intervals),
120 - 200 (In 40 litre intervals), or 250 - 650
(In 50 litre intervals).
* Initial factory setting: 160 litre.
Priority
Bath fill volume setting will be flashing
(Eg. 200 litre.)
* The level can only be adjusted while the
indicator is flashing.
* After ten seconds, the remote
will again display the temperature.
* For Bathroom controller.
To alter the bath fill volume press the
priority button after the bath fill button.
Water Temperature
The temperatures settings below are only examples. The
(
C :
°
temperature setting necessary will depend on the usage,
the length of piping or seasons.
37 38 39 40 41 42 43 44 45 46 47 48
Warm
Warmer
Increase
Decrease
Bath Fill
Burner on
Temp.
Hot
* Initial factory setting: 40°C
5
Turn on hot
water.
On On
Bath Fill
Priority Burner on
Temp.
)
21