Checking The Engine's Cooling Air Intake; Fitting The Cutting Head - Husqvarna R 322T AWD Owner's Manual

Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
WARNING! The cooling air intake rotates
!
when the engine is running. Mind your
fingers.

Fitting the cutting head

WARNING! Wear protective glasses when
!
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
1 Place the Rider on a flat surface and apply the parking
brake.
2 Check that the lever for setting the cutting height is in the
lowest position and that the lifting lever for the cutting unit
is in mowing position.
Maintenance
3 Push the equipment frame down and place the catch
against the frame.
4 Engage the belt in the belt holder.
5 Push the deck in and put the front guide plugs in the
grooves on the equipment frame, one on each side.
!
6 Lift up the cutting unit
7 Push the unit in so that the interior plugs touch the bottom
of the equipment frame's grooves.
WARNING! Observe caution to avoid
trapping your hand.
– 27
English