Control Cable - Pioneer LX01BD Operating Instructions Manual

02
Rear panel
5 Connect the Blu-ray disc player to the receiver subwoofer.
a. Plug the control cable into the CONTROL OUT 1 jack on the side
of the receiver subwoofer.
Plug the other end of the cable into the CONTROL IN jack on the
rear of the Blu-ray disc player.
b. Plug the HDMI cable into the HDMI IN 1 jack on the rear of the
receiver subwoofer.
Plug the other end of the cable into the HDMI OUT jack on the
rear of the Blu-ray disc player.
Note that unless the control cable is connected, you can't use
the remote control with the Blu-ray disc player.
6 Connect the receiver subwoofer to your TV.
• Connect the HDMI OUT jack on receiver subwoofer to an HDMI
input on your TV.
• You can have audio from the receiver subwoofer, as well as
audio and video from the Blu-ray disc player, output to your TV
by connecting with a single HDMI cable.
14
En
FRONT SURROUND SURROUND BACK
L
R L
R
AUDIO OUT ( 2 ch ) AUDIO OUT ( 7.1 ch )
OPTICAL
CONTROL DIGITAL
IN OUT
HDMI
OUT IN 3 IN 2 IN 1
SYSTEM
6
To HDMI input
CENTER
VIDEO OUT
Y
VIDEO
SUB WOOFER
P
B
HDMI OUT
P
R
COMPONENT
S-VIDEO
VIDEO
5
Receiver subwoofer
Side panel
OUT 1 OUT 2
IN 1 IN 2
CONTROL OPTICAL
DIGITAL
7
From digital audio
output (optical)
TV
7 Connect an audio cable from your TV to the receiver
subwoofer.
• To listen to TV audio on this unit, connect the TV's audio output
to DIGITAL OPTICAL IN 1 on the receiver subwoofer.
To use the HDMI Control function when you are connected to a
supported Pioneer Flat Screen TV, you must connect via HDMI.
• You must first set 'TV Input' to switch the audio from a Flat
Screen TV with the HDMI Control function or to switch the input
source of this unit to TV audio and operate your TV with the
supplied remote control. For more information, see Operating
Pioneer Flat Screen TV and TVs on page 21 and Audio input
settings from TVs (TV Input) on page 40.
AC IN
Blu-ray disc player
-