GE 21 Owner's Manual And Installation page 33

REPLACING THE DOORS
INSTALL CENTER HINGE
1
Install the center hinge on each side.
REHANG REFRIGERATOR DOORS
2
A Lower the refrigerator door onto the
center hinge pin. Ensure that the plastic
hinge pin thimble is on the center hinge
pin or inside door hinge pin hole located
in the bottom of the door.
Hinge Pin
B Securely tape the door shut with masking
tape or have a second person support
the door.
C Route wires through bottom right hinge
pin slot. Insert the top hinge pin into the
hinge hole on top of the refrigerator door.
Make sure the door is aligned with the
cabinet and opposite door. Attach the
hinge to the top of the cabinet loosely
with the bolts.
(appearance may vary)
D On right-hand doors, carefully pass the
wires and water line through the center
hinge pin. Then connect the water line
and 4-pin connector.
Water Line
Installation Instructions
(Double Door Refrigerator Models only)
Bottom
Right Hinge
Pin Slot
Center
Hinge Pin
4-Pin
Connector
33
REHANG REFRIGERATOR DOORS (CONT.)
2
E Make sure the gasket on the door is
flush against the cabinet and is not folded.
Make sure the door is straight and the gap
between the doors is even across the front.
While holding the aligned door in place,
tighten the top hinge bolts. Replace the
hinge cover and screw.
Hinge Cover
Top Hinge Bolts
(appearance may vary)
REPLACE OPPOSITE DOOR
3
Follow the same procedure on the
opposite door. There is no water line or
hinge cover.
ALIGN DOUBLE DOORS
4
If the top of the doors are uneven, first
try to raise the lowest door by turning the
leveling leg on the same side as the door
until the doors are even. If the unit rocks,
re-adjust the leveling legs to the extent
that the unit is stable.
If the doors remain uneven, turn the
adjustable pin to raise, or lower, the left
door to match the right door. Use a 1/4"
Allen wrench to turn the pin.
REPLACE FREEZER DRAWER
5
Refer to the Replacing the Freezer Drawer
section for instructions.
Adjustable pin