Installing The Refrigerator; Level The Refrigerator - GE 21 Owner's Manual And Installation

INSTALLING THE REFRIGERATOR

PLUG IN THE REFRIGERATOR
2
On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the O (off) position.
START THE ICEMAKER
3
Set the icemaker power switch to the l position.
The icemaker will not begin to operate until it
reaches its operating temperature of –9°C or below.
It will then begin operation automatically if the
icemaker power switch is in the l position.
Power
switch
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
Installation Instructions
22
(cont.)
PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location. Make
sure the back side of the refrigerator engages the
anti-tip bracket properly. The anti-tip floor bracket
should line up with the cutout in the back bottom
of the refrigerator, and fit through the cutout
when the refrigerator is pushed into position.
(Refer to page 18, Step 2A for more information.)

LEVEL THE REFRIGERATOR

5
Turn the front roller
adjusting screws clockwise
to raise the refrigerator,
counterclockwise to lower
it. Use a 3/8" hex wrench
with extension, or an
adjustable wrench.
To adjust the rollers on 21
These models also have rear adjustable rollers
so you can align the refrigerator with your
kitchen cabinets. Use a 3/8" hex wrench with
extension to turn the screws for the rear rollers—
clockwise to raise the refrigerator,
counterclockwise to lower it.
Roller adjusting screws
models:
' Counter Depth