Oce im5530 Operator's Manual page 59

2
Place the original(s). See the following
pages to set the originals.
• P.57 "Originals sizes and types"
• P.60 "Placing originals on the glass"
• P.62 "Using the Reversing Automatic Document Feeder"
The originals are copied in the order of being scanned.
3
Select the copy modes as required. When you want to copy more than
one set, key in the desired number of copies.
• Press the [CLEAR] button on the control panel to correct the number keyed in.
• Note that some combinations of copy modes are restricted. (
Matrix")
• Once the [START] button on the control panel has pressed, any change in copy modes (including setting of the
previously divided sets of originals) cannot be applied afterward.
4
Press the [START] button.
• Copying starts.
When you copy by placing originals on the original glass (e.g.
using the sort mode, or making 1-sided original 2-sided copies),
the data of these originals are scanned into the memory. In this
case, proceed to steps 5 and 6.
5
Place the next original, and press the [START] button.
• Data scanning of this original starts.
• The next original will also be scanned in the same manner when you press the [YES] button on the touch
panel, and then press the [START] button on the control panel.
• Repeat the above procedure until the scanning of the last page of the original finishes.
P.349 "4.Copying Function Combination
2
55