Oce im5530 Operator's Manual page 278

6.Error Code (Cont.)
Scan Job
Error code
Remote Scan
2A20
2A40
2A50
2A51
Scan to E-mail
2C10, 2C12,
2C13, 2C20-
2C22
2C11, 2C62
2C14
2C15
8
2C30
2C31, 2C33
2C32
2C40
2C61
2C63, 2C64
2C65, 2C66,
2C69
2C6A
2C6B
274
8.JOB STATUS
Problem
Failed to acquire
resource
System fatal error
Job canceling
Power failure
Illegal Job status
Not enough memory
Invalid parameter
specified
Message size
exceeded limit or maxi-
mum size
Failed to create direc-
tory
Failed to create file
Failed to delete file
Failed to convert
image file format
Failed to read
AddressBook
Invalid Domain
Address
Failed to connect to
SMTP server
Failed to send E-Mail
message
Invalid address speci-
fied in From: field
Perform the job in error again.
If the error still occurs, turn the power OFF and then back ON.
Perform the job in error again.
Turn the power OFF and then back ON. Perform the job in error
again.
Job was canceled.
Check if the power cable is connected properly and it is inserted
securely. Check if the power voltage is unstable.
A system error has occurred during sending an E-mail. Retry it.
If the error still occurs, contact your service representative.
Scan job exceeded the limit or maximum size. Send your docu-
ments separately.
Make sure you specify the settings correctly and try again.
Fragment the message into several smaller-sized ones and
send them again.
Make sure that the access privilege to the storage directory is
writable and the server or local disc has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disc has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disc has a sufficient space. Then
retry the scan.
Turn the power OFF and then back ON.
Retry the scan. If the error still occurs, contact your service rep-
resentative.
Turn the power OFF and then back ON.
Retry the job in error. Reset the data in the Address Book and
retry it. If the error still occurs, contact your service representa-
tive.
Ask your administrator to set the IP address.
Make sure the SMTP server is correctly working, or the SMTP
server address has been set correctly. Then retry the scan.
Turn the power OFF and then back ON. Retry the scan. If the
error still occurs, contact your service representative.
Ask your administrator to check if there is an illegal character in
the E-mail address of the equipment. Delete the illegal charac-
ter and reset the appropriate E-mail address, then perform the
job again.
What to do