Gauge Reading - MULTIQUIP WHISPERWATT DCA-220SSVU Operation And Parts Manual

DCA-220SSVU (50 HZ)— GENERATOR OUTPUTS/ GAUGE READING
How to Read the Output Terminal Gauge.
The AC ammeter and AC voltmeter change-over switches
on the control panel DO NOT effect the generator output.
They are provided to help observe how much power is being
supplied, produced at the UVWO terminals lugs.
When the voltage change-over board is jumpered for
240V operation (See Figures 17 and18), place the AC Volt-
meter Change-Over Switch (See Figures 19 and 20) to the
W-U position and the AC Ammeter Change-Over Switch
(Figure 19) to the U or W position to read the output on the
selected leg.
Figure 16. Voltage Change-Over Board
DCA-220SSVU (50 Hz) — OPERATION AND PARTS MANUAL — REV. #0 (04/18/06) — PAGE 29
240V Configuration
3Ø,
Figure 17. AC Voltmeter
Change-Over Switch
Figure 19. AC Ammeter
Change-Over Switch
NOTE
Figure 18. AC Voltmeter Gauge
(Volt reading on W-U Lug)
Figure 20. AC Ammeter
(Amp reading on U lug)
The ammeter gauge will only
show a reading when the
Output Terminal Lugs are
connected to a load and in use.
1